How do you tighten the Fan belt on a 1993 Jeep Wrangler?

I looked through the manual and there's nothing on fan belts. My stepdad and I looked for the lever that ussually comes off of the generator to tighten a fan belt but there isn't one on my jeep. He has a Jeep, but his is a cherokee, if someone would help be I would greatly appreciate it!! THanks!How do you tighten the Fan belt on a 1993 Jeep Wrangler?To replace a worn belt, locate the idler or generator pulley. Loosen the hold-down fastener for the idler or generator pulley. Pry the idler or generator pulley inward to release the belt tension and remove the belt. Match the old belt up for size with the new replacement belt. Observe the belt routing diagram in the engine compartment. Install the new belt over each of the drive pulleys. Often the manufacturer recommends a sequence for feeding the belt around the pulleys. Pry out the idler or generator pulley to put tension on the belt.





http://www.autozone.com/az/cds/en_us/090How do you tighten the Fan belt on a 1993 Jeep Wrangler?If you have a 4.0L the adjustment bolt is under the power steering pump. Loosen the bolts that hold the pump to the brackets and tighten the long bolt underneath. Take a look at it. You'll figure it out.How do you tighten the Fan belt on a 1993 Jeep Wrangler?On the 4.0 the adjustment bolts are located under the power steering pump.